Bindig OC200 to cloud failed

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Bindig OC200 to cloud failed

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Bindig OC200 to cloud failed
Bindig OC200 to cloud failed
2020-12-14 11:54:11 - last edited 2020-12-15 02:22:49
Model: OC200  
Hardware Version: V1
Firmware Version: 1.7.1 Build 20201016 Rel.62818

Hello,

 

Has anyone met that binding a new OC200 with TP-Link ID says: " Invalid controller. "?

 

Adding it with QR code says the same error.

 

Any idea?

 

 

  0      
  0      
#1
Options
1 Accepted Solution
Re:Bindig OC200 to cloud failed-Solution
2020-12-14 15:57:10 - last edited 2020-12-15 02:22:49

@ExpGy 

 

Yes, I got 2 times and reported.

 

The current solution is to backup the configuration, factory reset and bind the controller to the cloud via wizard setup and then restore the backup.

 

To me happened because I upgraded from 4.1.5 to 4.2.4 skipping the cloud registration wizard.

 

Regards

Recommended Solution
  2  
  2  
#2
Options
2 Reply
Re:Bindig OC200 to cloud failed-Solution
2020-12-14 15:57:10 - last edited 2020-12-15 02:22:49

@ExpGy 

 

Yes, I got 2 times and reported.

 

The current solution is to backup the configuration, factory reset and bind the controller to the cloud via wizard setup and then restore the backup.

 

To me happened because I upgraded from 4.1.5 to 4.2.4 skipping the cloud registration wizard.

 

Regards

Recommended Solution
  2  
  2  
#2
Options
Re:Bindig OC200 to cloud failed
2020-12-14 18:45:51 - last edited 2020-12-15 02:22:49

@Emitplink 

 

Thank You for bringing the solution!

 

It works now the way it should have worked!

 

  0  
  0  
#3
Options