TL-SG1024D leds blinking together

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-SG1024D leds blinking together

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-SG1024D leds blinking together
TL-SG1024D leds blinking together
2021-01-04 00:45:40
Model: TL-SG1024D  
Hardware Version:
Firmware Version:

Hello.  What does it mean or what is happening when all ports LEDs blink together and connection with router is down.

Disconnecting patch cords will not stop the blinking.

To have everything back to normal, the switch has to be switched off and on again.

Thanks

  0      
  0      
#1
Options
2 Reply
Re:TL-SG1024D leds blinking together
2021-01-04 11:17:05

Dear @SCH123,

 

What does it mean or what is happening when all ports LEDs blink together and connection with router is down.

 

It may be caused by a network loop. You may unplug the Ethernet cables from the switch one by one to have a check. 

 

Besides, ensure the switch is not suffering from a power shortage. Insufficient power may lead to abnormal behaviors, use the original power cord is always recommended.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options
Re:TL-SG1024D leds blinking together
2021-01-04 16:13:58

@Fae 

 

Thanks for your reply, but I have already tried that.  Switch has to be unplugged from the mains to work properly again. Regards 

  0  
  0  
#3
Options