TL-R605 OC200 - Not Showing All Lan Devices

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-R605 OC200 - Not Showing All Lan Devices

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-R605 OC200 - Not Showing All Lan Devices
TL-R605 OC200 - Not Showing All Lan Devices
2021-01-29 10:08:28
Model: ER605 (TL-R605)  
Hardware Version: V1
Firmware Version: 1

Just installed the Tl-R605 along side 3 EAP-225.

 

I Have around 80 clients on the LAN / WIFI but the Omada Software Controller does not show them all.. It seems to be that some of the LAN connected devices with Static IP's set on the clients themselves are no where to be seen..

 

It makes life very difficult when trying to allocate static IP's if i can't see a full list from my router of what's already in use.

 

The thing is, i KNOW atleast some of them have been on the list before as i've renamed them..

 

 

There should be devices showing up on 192.168.2.1 , .2 , .3, .4, .5, .10, .11 for example

  0      
  0      
#1
Options
2 Reply
Re:TL-R605 OC200 - Not Showing All Lan Devices
2021-02-17 00:06:02

I have almost the same problem but apparently only for hard wired clients. I used to have the problem for wireless as well but it was fixed by upgrading controller to 2.4.11. The clients/managed switches suddenly vanish from the list and appear back in few minutes. At times, the list starts with a few items, and then suddenly grows.

In the logs (under Events), it is showing that my managed switches and some other wired clients disconnect with this message:

 

5E-3C-22-41-D0-85 was disconnected from network "LAN" on Router(connected time:18m connected, traffic: 0Bytes).

 

Just to connect back after 4 minutes:


5E-3C-22-41-D0-85 is connected to Router on LAN network.

 

The funny thing is that while typing this, the machine I am using suddenly appeared in logs as disconnected and disappeared from clients list, however, I'm fully connected and even internet connection works fine.

To me, it is purely a software glitch in Tl-R605. I'm running firmware 1.0.0 Build 20200930 Rel.36519

 

 

  0  
  0  
#2
Options
Re:TL-R605 OC200 - Not Showing All Lan Devices
2021-02-17 16:28:28

@MaziarR 

 

Sorry yes, i should of specified, this is only for LAN connections.. i have loads that randomly appear and dissapear.. seems a prety fundamental role of a router to know whats connected to the network.

  1  
  1  
#3
Options

Information

Helpful: 0

Views: 1219

Replies: 2

Related Articles