POE issues concerns between TL-SG108PE V3 switch and CPE510 AP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

POE issues concerns between TL-SG108PE V3 switch and CPE510 AP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
POE issues concerns between TL-SG108PE V3 switch and CPE510 AP
POE issues concerns between TL-SG108PE V3 switch and CPE510 AP
2021-02-18 22:31:12
Model: TL-SG108PE  
Hardware Version: V3
Firmware Version: 1.0.0 Build 20200415 Rel.54962

I am trying to Power Up a CPE510 using the POE ports of the TL-SG108PE and it is not working.

 

I tried to Power Up an EAP-225 Outdoor unit using the same TL-SG108PE and it is working fine.

 

Why I´m not being able to Power Up a CPE510?

 

I tried to configure the TL-SG108PE via its WEB Gui Admin Software, but I can not being able to manage any type of power parameters of the POE Ports, because this WEB admin software shows me only 2 limited POE options and neither are referred to manage power in Watts o somethings like these at its shows the user guide PDF.

 

I bought this TL-SG108PE switch because I assume it should power up at least 3 or 4 CPE510 Outdoor units, but it can not power up just one of them.

 

What I´m doing wrong?

 

Best regards

 

Ernesto

  0      
  0      
#1
Options
1 Reply
Re:POE issues concerns between TL-SG108PE V3 switch and CPE510 AP
2021-03-13 19:11:32

@eantelo 

 

Similar Issue with CPE210. My POE switch TL-SG108PE 2.0 does not power CPE210 outdoor Switch. 

Firmware Version 1.0.0 Build 20180720 Rel.62267
Hardware Version

TL-SG108PE 2.0

  0  
  0  
#2
Options