Missing Band steering EAP245 with OMADA controller
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I noticed in a recent update that my EAP 245 v3 adopted by my OC200 is missing some advanced options like beam forming and band steering. I have had those enabled in the past. IS this from a recent update? My eap is HW version 3 and firmware version5. The OC200 is Version:4.2.8 Build:
1.7.3 Build 20201119 Rel.63433
What are your thoughts?
Thanks
I found it just after posting
For those else missing the option, it is in a different place than I thought it was. It is under SITES not wireless networks
Path:
1. Click on Settings.
2. Click on Site.
3. Scroll down to the Advanced Features check the box and click to enable
4. Scroll down To Advanced Features and check the box to enable Band steering.
I found it just after posting
For those else missing the option, it is in a different place than I thought it was. It is under SITES not wireless networks
Path:
1. Click on Settings.
2. Click on Site.
3. Scroll down to the Advanced Features check the box and click to enable
4. Scroll down To Advanced Features and check the box to enable Band steering.