TL-605 firewall and virtual server?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-605 firewall and virtual server?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-605 firewall and virtual server?
TL-605 firewall and virtual server?
2021-03-09 03:30:55 - last edited 2021-04-16 10:31:40
Model: ER605 (TL-R605)  
Hardware Version: V1
Firmware Version: 1.01

Hello,

 

I can't seem to open ports for my servers.  I have the NAT port forwarding entries, but the ports are closed for the WAN side.  I have looked all around the GUI and can't seem to find any real firewall rules.  After searching it looks like I need to use the virtual server feature.  But for the life of me, I can't find that either.  It's on the datasheet and I am using the Omada controller.  It should be available right?

  0      
  0      
#1
Options
1 Accepted Solution
Re:TL-605 firewall and virtual server?-Solution
2021-03-10 20:47:39 - last edited 2021-04-16 10:31:40

@Grohk 

 

Fixed this problem.  It was an issue with ip passthrough from my modem.

 

I unadopted the gateway and went in through the web admin interface.  Still wasn't working, so I looked at the modem.  The NAT rule in the controller worked fine once I got that sorted, even though it wasn't labelled Virtual Server.

Recommended Solution
  3  
  3  
#2
Options
1 Reply
Re:TL-605 firewall and virtual server?-Solution
2021-03-10 20:47:39 - last edited 2021-04-16 10:31:40

@Grohk 

 

Fixed this problem.  It was an issue with ip passthrough from my modem.

 

I unadopted the gateway and went in through the web admin interface.  Still wasn't working, so I looked at the modem.  The NAT rule in the controller worked fine once I got that sorted, even though it wasn't labelled Virtual Server.

Recommended Solution
  3  
  3  
#2
Options

Information

Helpful: 0

Views: 437

Replies: 1

Related Articles