Loadbalancer is loosing connection when one of the WANs down

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Loadbalancer is loosing connection when one of the WANs down

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Loadbalancer is loosing connection when one of the WANs down
Loadbalancer is loosing connection when one of the WANs down
2021-03-25 14:41:04 - last edited 2021-04-16 10:21:41
Model: TL-R480T+  
Hardware Version: V5
Firmware Version: 5.1.2 Build 20130116 Rel.45581s

I have 480T+ loadbalancer I have two WANs connections  connected,  but when one of the WANS get disconnected  I loose the Internet connection, I have to manually  disconnect the the lost WAN in order for me to access  Internet  again. 

 

The only reason someone  would buy loadbalancer is to have constant connection and the loadbalancer  would  automatically switch between WANs.

 

I am not sure where is the issue 

  1      
  1      
#1
Options
2 Reply
Re:Loadbalancer is loosing connection when one of the WANs down
2021-03-26 16:34:43 - last edited 2021-04-16 10:21:41

@MohamedAdam 

 

Have you configured Load Balancing or Link backup under Transimission?

 

Best regards

 

  1  
  1  
#2
Options
Re:Loadbalancer is loosing connection when one of the WANs down
2021-03-26 16:46:39 - last edited 2021-04-16 10:21:41
I configured it as a loadbalancer. I want both WANs to be working at the same time. When you set it as a link backup, the secondary WANs works only if the main WAN gets disconnected
  1  
  1  
#3
Options

Information

Helpful: 1

Views: 441

Replies: 2