Business Community > Controllers > How to allow VPN Server traffic between IPSec (Site) connections
< Controllers

How to allow VPN Server traffic between IPSec (Site) connections

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How to allow VPN Server traffic between IPSec (Site) connections

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to allow VPN Server traffic between IPSec (Site) connections
How to allow VPN Server traffic between IPSec (Site) connections
2021-06-28 10:08:17
Model: ER7206 (TL-ER7206)  
Hardware Version: V1
Firmware Version: 1.1.0

Hello. 

 

The connection between Site 1-2 via IPSec (site-to-site) was successful.


It works normally for internal LAN communication with each other.

 

And here I want to enable communication to Site2 when connected to the VPN Server.

If you connect VPN Server - L2TP at site 1, you can connect only to VPN Gateway 1. How do I get traffic to flow to Site 2 ?

 

The setting is controller mode.
Omada 4.3.5 Controller in use.

 

Google Translate was used. Please understand.

 

Thanks.

 

  1      
 
  1      
 
#1
Options
4 Reply
Re:How to allow VPN Server traffic between IPSec (Site) connections
2021-06-30 06:33:58

@canopus 

Hi, it should be work as you want without other configuration.

 

How do you set up the Router as L2TP VPN Client? Router should be able to connect to different VPN server and using different tunnels.

Just striving to develop myself while helping others.
  0  
  0  
#2
Options
Re:How to allow VPN Server traffic between IPSec (Site) connections
2021-06-30 09:51:43

@Virgo 

 

Hello. 
The client connection to site1's LT2P server is connected to a mobile or laptop terminal from the outside.
I wish that traffic flowed well to site2 while connected to the L2TP server, but it was not possible.

  0  
  0  
#3
Options
Re:How to allow VPN Server traffic between IPSec (Site) connections
2021-07-01 03:52:46

@canopus  

Currently, because of the mechanism of the Controller, like the VPN IP pool and DHCP IP pool is in different IP range, and so on. so this problem happens.

This problem should be resolved on the later update.

Just striving to develop myself while helping others.
  2  
  2  
#4
Options
Re:How to allow VPN Server traffic between IPSec (Site) connections
2021-07-20 21:48:21

@Virgo 

 

Thanks for the reply.
I hope tp-link solves this problem!

  0  
  0  
#5
Options

Information

Helpful: 1

Views: 1197

Replies: 4

About Us
Press
Copyright © TP-Link Corporation Limited. All rights reserved.