Guide to gracefully removing device from Omada Controller
Is there any guidance to removing devices from being controlled by the Omada Controller, or is the only option to perform a factory reset on any of the equipment you want to disconnect?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Emitplink Thanks, I'll give that a try if I can get my controller back running.
Does that actually allow for direct login with the device, or does that simply disconnect it from this Controller but not move it out of "Controller mode"?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
A noob question.
I have just installed omada controller 5.0.15 and adopted two switches (TL-SG2428P 1.0), then decided to remove them. I selected Forget option.
Now, I'm unable to access my switches as none of the credentials I've tried work.
Also, IP addresses on both switches seems to have been set to: 192.168.0.1 ?
Is there any way to access them w/o doing a hard reset?
- Copy Link
- Report Inappropriate Content
It appears Omeda controller has hijacked my switches, even bore adopting them and changed both to the same IP (???): 192.168.0.1.
I thought UniFi controller was bad....
I'll stick with CISCO for anything production.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 17173
Replies: 5
Voters 0
No one has voted for it yet.