Force client to WAN/LAN1 in a multi-WAN setup

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Force client to WAN/LAN1 in a multi-WAN setup
Force client to WAN/LAN1 in a multi-WAN setup
2021-08-09 17:32:14
Hardware Version:
Firmware Version:

Hi,

 

I am trying to find if it's possible to force a client (wireless or wired) o use a specific outgoing WAN port. I have 2 WANs: [WAN] and [WAN/LAN1] connected to two different ISPs. I need to authenticate with one of my ISPs using the IP assigned by them to create an account, but when I look at my external IP address, it is using the other ISP.

 

I think in general it would be nice to be able to redirect different clients to different networks. I know that the router's load balancing features do this automatically, but for some clients I would like to manually specify an outgoing route. Is this possible?

 

Thanks.

Main Gateway: TL-ER7206 Switch: TL-SG3428 APs: EAP620 HD x2
0
0
#1
Options
1 Reply
Re:Force client to WAN/LAN1 in a multi-WAN setup
2021-08-09 18:15:52

@Unraider 

 

look at policy routing under Transmission menu

 

 

 

 

 

0
0
#2
Options