ER605 Basic routing assistance

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ER605 Basic routing assistance

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
ER605 Basic routing assistance
ER605 Basic routing assistance
2021-08-18 03:10:28 - last edited 2021-08-25 17:22:13
Model: ER605 (TL-R605)  
Hardware Version: V1
Firmware Version: ER605(UN)_V1_1.1.1_20210723

I haven't been able to get a simple routing setup to work properly on this router. Hoping someone cant give me a hand:

 

192.168.1.0/24 (internal network)  -> 192.168.12.1 (Internet gateway) -> Internet

 

ER605:

LAN1: 192.168.1.5

WAN1: 192.168.12.1

 

I want to use 192.168.1.5 as the default gateway on the internal network. In the various combinations of static routes to 0.0.0.0/0 (LAN1) -> 192.168.12.1 have failed.

 

Can someone steer in the right direction? I think there's something obvious I'm missing and haven't been able to find.

 

TIA

  0      
  0      
#1
Options
1 Accepted Solution
Re:ER605 Basic routing assistance-Solution
2021-08-21 02:58:00 - last edited 2021-08-25 17:22:13

@pnwfc 

If you just have a single WAN, you don't need to configure anything. All traffic will go to the default gateway (that is the LAN IP of the router), and to the WAN port. This is what a router with NAT should do by default. Maybe I didn't catch your real meaning. But static routing is used to direct traffic within LAN. It won't involve WAN traffic, as I think.

Recommended Solution
  2  
  2  
#4
Options
4 Reply
Re:ER605 Basic routing assistance
2021-08-19 07:02:41
Do you have multi-WAN connections? If you want to direct a certain LAN network to a certain WAN connection, you should configure policy routing, not static routing.
  0  
  0  
#2
Options
Re:ER605 Basic routing assistance
2021-08-19 14:52:26 - last edited 2021-08-19 14:55:44

@pnwfc 

 

Single WAN connection.

 

Profile based routing turned out to be the answer. Static routing would not accept a 0.0.0.0/0 route, but Profile does implcitly when using the default IP_LAN & IP_ANY groups.


Thank you.

 

 

  0  
  0  
#3
Options
Re:ER605 Basic routing assistance-Solution
2021-08-21 02:58:00 - last edited 2021-08-25 17:22:13

@pnwfc 

If you just have a single WAN, you don't need to configure anything. All traffic will go to the default gateway (that is the LAN IP of the router), and to the WAN port. This is what a router with NAT should do by default. Maybe I didn't catch your real meaning. But static routing is used to direct traffic within LAN. It won't involve WAN traffic, as I think.

Recommended Solution
  2  
  2  
#4
Options
Re:ER605 Basic routing assistance
2021-08-25 17:22:38
Worked. Thanks.
  0  
  0  
#5
Options