WAN connection problems with TL-R600VPN
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
WAN connection problems with TL-R600VPN
Region : Australia
Model : TL-R600VPN
Hardware Version : V1
Firmware Version :
ISP :
I have just installed a new TL-R600VPN router/switch. The LAN side is working well but I cannot get the WAN side to communicate with my cable modem. My set up is simple as I am just using the TL-R600VPN as a high speed home router switch. I chose this product as it is faster than the cheap routers usually used in homes. I have a 100mb/sec cable connection to my house. So I have set the product to WAN Dynamic addressing but it never talks to the modem. I dont use the VPN capability at all but Is there some VPN parameter that I need to set in order to use the product in its simplest application as a basic router/switch in the home?
Model : TL-R600VPN
Hardware Version : V1
Firmware Version :
ISP :
I have just installed a new TL-R600VPN router/switch. The LAN side is working well but I cannot get the WAN side to communicate with my cable modem. My set up is simple as I am just using the TL-R600VPN as a high speed home router switch. I chose this product as it is faster than the cheap routers usually used in homes. I have a 100mb/sec cable connection to my house. So I have set the product to WAN Dynamic addressing but it never talks to the modem. I dont use the VPN capability at all but Is there some VPN parameter that I need to set in order to use the product in its simplest application as a basic router/switch in the home?
