Port Forwarding for Server connected after Point to Point Bridge(WA-5210G)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Port Forwarding for Server connected after Point to Point Bridge(WA-5210G)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Port Forwarding for Server connected after Point to Point Bridge(WA-5210G)
Port Forwarding for Server connected after Point to Point Bridge(WA-5210G)
2013-05-15 10:05:23 - last edited 2021-08-21 03:24:25
Region : Malaysia

Model : TL-R470T+

Hardware Version : V2

Firmware Version : 5.1.0 Build 20120510 Rel.58982s

ISP :


Currently I have two office which i connected the network with WA-5210G with Bridge (Point to Point) mode. I need to configure port forwarding for my CCTV where it works properly with the one connected directly to the Load Balancer. However i have issue setting up port forwarding for any network connected after the bridge.
  0      
  0      
#1
Options
2 Reply
Re:Port Forwarding for Server connected after Point to Point Bridge(WA-5210G)
2013-05-17 09:49:39 - last edited 2021-08-21 03:24:25
However i have issue setting up port forwarding for any network connected after the bridge.

you want to do port forwarding for a local network? what's the network topology?
  0  
  0  
#2
Options
Re:Port Forwarding for Server connected after Point to Point Bridge(WA-5210G)
2013-05-17 22:40:26 - last edited 2021-08-21 03:24:25
Set the wrong gateway on the server. Correcting it makes port forwarding work.
  0  
  0  
#3
Options