EAP225-Outdoor antenna rubber gasket/seal problem

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP225-Outdoor antenna rubber gasket/seal problem

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP225-Outdoor antenna rubber gasket/seal problem
EAP225-Outdoor antenna rubber gasket/seal problem
2021-10-08 20:10:11
Model: EAP225-Outdoor  
Hardware Version: V1
Firmware Version:

I purchased a EAP225-Outdoor unit and I've noticed that both antennas don't sit flush over the gaskets so water will get in and damage the connector. Is there any way I could fix this? In the photo I've attached both antennas are tightened all the way down, but the antenna base sits at an angle over the main unit body.

 

 

  0      
  0      
#1
Options
1 Reply
Re:EAP225-Outdoor antenna rubber gasket/seal problem
2021-10-11 11:04:06

@mkby 

 

Can you not loosen them off, use a bead of clear silicon sealant and then tighten them back up ?

 

Regards

 

Ben

  0  
  0  
#2
Options