PharOS management problem

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

PharOS management problem

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
PharOS management problem
PharOS management problem
2021-11-25 17:11:07
Model: CPE710  
Hardware Version: V1
Firmware Version: 2.2.1 Build 20201201 Rel. 56722 (0000)

Hi.

 

I have set up two CPE710 without any issues.

 

First one is called SENDER, connected to my home network over lan cable and running in operation mode Access Point. It has an IP x.x.x.10

 

Second CPE710 is mounted on my neighbours house roof and running in operation mode: Client with IP x.x.x.11

 

The connection is stable, I can login to both devices from my home PC.

 

The problem is with the PharOS control software running on my PC.

 

It does discover both devices but is not able to manage the SENDER:

 

 

 

Of course I use correct credentials here:

 

Where is the problem ?

 

 

  0      
  0      
#1
Options
3 Reply
Re:PharOS management problem
2021-11-26 04:24:03

@Mikolaj 

 

Note that normally the first three parts of the IP address should be the same, can you ping through to the AP CPE IP address on this PC?
Or you can delete the AP cpe entry and try scanning again.

Just striving to develop myself while helping others.
  0  
  0  
#2
Options
Re:PharOS management problem
2021-11-26 10:34:06 - last edited 2021-11-26 10:34:18

@Virgo 

 

1. I can ping ANY address in my network from SENDER

2. Tried that many times

  0  
  0  
#3
Options
Re:PharOS management problem
2021-11-29 07:42:37 - last edited 2021-11-29 07:44:58

@Mikolaj 

is that possible some kind of port issue? Have you tried to turn off the anti virus on your PC? 

Reset the SENDER and set up again?

Does the PC that manages can ping the SENDER CPE's IP?

  0  
  0  
#4
Options