Firmware/Hardware Version

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Firmware/Hardware Version

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Firmware/Hardware Version
Firmware/Hardware Version
2021-12-14 11:01:57
Model: EAP225  
Hardware Version: V1
Firmware Version: 1.4.0 Build 20180323 Rel. 32579

Hi,

 

Apologies, another log4j related post. Have looked through the other threads but can't get an answer that I need specifically for me.

 

I currently have 2 x EAP225 on the hardware version 1.0/2.0 and firmware version 1.4.0 Build 20180323 Rel. 32579.

 

I then have 1 x EAP225 on the hardware version 3.0 and firmware version 2.5.0 Build 20190404 Rel. 57144.

 

The end goal is to get my Omada Controller updated from 3.2.7 to the newest version (5.0.15). Encountering an error when trying to upgrade, I can see this is down to the fact I have the 2 x EAP225 with hardware version 1.0/2.0.

 

Can someone with any insight please advise what I would need to do to allow 5.0.15 to install, based on my current setup?

 

Much appreciated, thanks.

  0      
  0      
#1
Options
1 Reply
Re:Firmware/Hardware Version
2021-12-15 08:46:08

Dear @Bazz_Choc ,

 

Bazz_Choc wrote

I currently have 2 x EAP225 on the hardware version 1.0/2.0 and firmware version 1.4.0 Build 20180323 Rel. 32579.

I then have 1 x EAP225 on the hardware version 3.0 and firmware version 2.5.0 Build 20190404 Rel. 57144.

The end goal is to get my Omada Controller updated from 3.2.7 to the newest version (5.0.15). Encountering an error when trying to upgrade, I can see this is down to the fact I have the 2 x EAP225 with hardware version 1.0/2.0.

Can someone with any insight please advise what I would need to do to allow 5.0.15 to install, based on my current setup?

 

EAP225 V1 and V2 are not compatible with SDN controller 5.0.15, you may check this list:

https://www.tp-link.com/en/omada-sdn/product-list/

 

so if you want to upgrade your controller to 5.0.15, you can only use these two EAPs under Standalone mode.
As for EAP V3, you can upgrade it to the latest firmware version, which is compatible with controller 5.0.15.

 

Best Regards!

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 826

Replies: 1

Related Articles