in the OMADA application/program, the device (ER7206) refuses to connect to the Internet

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

in the OMADA application/program, the device (ER7206) refuses to connect to the Internet

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
in the OMADA application/program, the device (ER7206) refuses to connect to the Internet
in the OMADA application/program, the device (ER7206) refuses to connect to the Internet
2021-12-23 08:05:14 - last edited 2022-01-19 11:23:09
Model: ER7206 (TL-ER7206)  
Hardware Version: V1
Firmware Version: Omada_Controller_V5.0.15_Window

Hello! The device (ER7206) works and is configured in WEB http://192.168.0.1/, but when you make the same settings in OMADA, the device adopt and then during self-configuration / configuration goes to Disconnect and the Internet stops working on all my 3 machines, I encountered is there anyone with such a problem? I will be glad to any advice!

Thank you

mdlttms

  0      
  0      
#1
Options
1 Accepted Solution
Re:in the OMADA application/program, the device (ER7206) refuses to connect to the Internet-Solution
2022-01-13 17:00:53 - last edited 2022-01-19 11:23:09

@Hank21 Hello!

Thanks for your cooperation, the problem was in my settings, I ran 2 standards at once/.

 

mdlttms

Recommended Solution
  0  
  0  
#5
Options
4 Reply
Re:in the OMADA application/program, the device (ER7206) refuses to connect to the Internet
2021-12-24 08:03:07

Dear @mdlttms ,

 

mdlttms wrote

Hello! The device (ER7206) works and is configured in WEB http://192.168.0.1/, but when you make the same settings in OMADA, the device adopt and then during self-configuration / configuration goes to Disconnect and the Internet stops working on all my 3 machines, I encountered is there anyone with such a problem? I will be glad to any advice!

 

In fact, the Disconnect status means that the router and controller are unable to communicate with each other.
To better assist you, may I know what's the physical connection(current topology) of your all devices?(You can draw a diagram of Network Topology simply if you don't mind.)
It would also be a good idea to provide the IP addresses of all the devices.

Can you ping through the router's IP address on the computer where the controller is installed?

 

Thanks for your cooperation and patience!

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options
Re:in the OMADA application/program, the device (ER7206) refuses to connect to the Internet
2021-12-24 19:57:31 - last edited 2021-12-25 18:33:17

@Hank21

Hello! 

           topology -- from the router via cable (RJ45)

           router - internet (1 port) cable , (2 port) pc1,  (3 port) pc2, pc3 (4port)

 

           ip pc1            192.168.0.152

           ip pc2           192.168.0.121

           ip pc3          192.168.0.135

            Internet connection on all DHCP machines

 

mdlttms

  0  
  0  
#3
Options
Re:in the OMADA application/program, the device (ER7206) refuses to connect to the Internet
2022-01-05 06:02:03

Dear @mdlttms ,

 

mdlttms wrote

           topology -- from the router via cable (RJ45)

           router - internet (1 port) cable , (2 port) pc1,  (3 port) pc2, pc3 (4port)

           ip pc1            192.168.0.152

           ip pc2           192.168.0.121

           ip pc3          192.168.0.135

            Internet connection on all DHCP machines

 

Thanks so much for your detailed information!

Please try to use your PC which is installed the controller to ping the router's IP address. just to check whether can ping through.

You can try to close the firewall and anti-virus software to test.

 

Best Regards!

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#4
Options
Re:in the OMADA application/program, the device (ER7206) refuses to connect to the Internet-Solution
2022-01-13 17:00:53 - last edited 2022-01-19 11:23:09

@Hank21 Hello!

Thanks for your cooperation, the problem was in my settings, I ran 2 standards at once/.

 

mdlttms

Recommended Solution
  0  
  0  
#5
Options

Information

Helpful: 0

Views: 871

Replies: 4

Related Articles