CPE710 re-establish remote Client

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

CPE710 re-establish remote Client

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CPE710 re-establish remote Client
CPE710 re-establish remote Client
2022-02-04 21:29:08 - last edited 2022-02-07 16:05:06

My paired CPE710 line-of- sight Ethernet devices worked faultlessly for 8 months then failed suddenly. After exhausting troubleshooting, I purchased a third unit, established it as my Access point successfully. The other unit needs now to be configured as Client. How do I do this when it needs internet to download Pharos and configure?

  0      
  0      
#1
Options
1 Reply
Re:CPE710 re-establish remote Client
2022-02-08 07:29:59

Dear @DaveAK

 

DaveAK wrote

My paired CPE710 line-of- sight Ethernet devices worked faultlessly for 8 months then failed suddenly. After exhausting troubleshooting, I purchased a third unit, established it as my Access point successfully. The other unit needs now to be configured as Client. How do I do this when it needs internet to download Pharos and configure?

 

Please check this post to learn more detailed information.

 

Best Regards!

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options