ER605 WAN port auto negotiating to 100 mbps

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ER605 WAN port auto negotiating to 100 mbps

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
ER605 WAN port auto negotiating to 100 mbps
ER605 WAN port auto negotiating to 100 mbps
2022-02-15 14:03:29
Model: ER605 (TL-R605)  
Hardware Version: V1
Firmware Version: 1.2.0 Build 20220114 Rel.76871

Hi,

 

I have an issue with ER605, I am using UFiber GPON as a modem and connected to my ER605 on the WAN port.

I noticed that after a few days the port is going to 100 Mbps only. I have to disconnect the device and connect it again and after a few tries, it works at 1000 Mbps.

 

Now in Omada in ER605 as the difference of the JetStream switches you cannot control the negotiation speed or at least I cannot find a way to always force it to 1000 Mbps.

if I connected the UFiber GPON to my PC directly I get right away 1000 Mbps. I have tried with several cables including cat 7 and same issue.

 

Any advice? 

 

  0      
  0      
#1
Options
1 Reply
Re:ER605 WAN port auto negotiating to 100 mbps
2022-02-16 11:09:39

  @Family_AM 

 

As far as I know, the controller does not yet support rate changes to the port of the gateway, can your modem be set to force negotiation to 1G?
Have you tested it by switching to a shorter cable?

There are long ethernet cables that are likely to cause problems with negotiation.

Just striving to develop myself while helping others.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 1785

Replies: 1

Related Articles