Forums

Stories

Knowledge Base

Business Community > WiFi > EAP610 seems to be using only 802.11a instead of ax

< WiFi

EAP610 seems to be using only 802.11a instead of ax

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP610 seems to be using only 802.11a instead of ax

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ASN45

LV1

2022-02-22 18:39:16

Posts: 4

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-02-22

EAP610 seems to be using only 802.11a instead of ax

2022-02-22 18:39:16

Model: EAP610

Hardware Version: V1

Firmware Version: 1.01 Build 20210511 Rel. 59602(5553)

Hello,

My single EAP610 AP seems to be using 802.11a only. All my network devices appear to have slow connections, and Windows reports the protocol used on my network card is 802.11a. I confirmed with my phone that the speed is limited to 20mbps download. I've checked the AP settings, and the IEEE802.11 Mode is set to b/g/n/ax mixed. It was working fine yesterday, but now everything has reverted to 802.11a. How can I fix this?

2 Reply

ASN45

LV1

2022-02-22 20:13:42

Posts: 4

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-02-22

Re:EAP610 seems to be using only 802.11a instead of ax

2022-02-22 20:13:42

@ASN45 I see what I did that caused this, but I don't know why. I turned off the QoS under Wireless / QoS, and suddently all my devices went to 802.11a. I turned QoS back on and everything went back to normal. I have QoS enabled on my router, and I turned this feature off on my EAP610 because my router handles this. Why did this happen?

Hank21

2022-02-23 08:14:49

Posts: 3011

Helpful: 657

Solutions: 399

Stories: 8

Registered: 2021-12-13

Re:EAP610 seems to be using only 802.11a instead of ax

2022-02-23 08:14:49

Dear @ASN45 ，

ASN45 wrote

@ASN45 I see what I did that caused this, but I don't know why. I turned off the QoS under Wireless / QoS, and suddently all my devices went to 802.11a. I turned QoS back on and everything went back to normal. I have QoS enabled on my router, and I turned this feature off on my EAP610 because my router handles this. Why did this happen?

In general, wireless can only negotiate up to 54Mbps(802.11a) when QoS WMM is turned off, so it is recommended to keep the default setting which is to enable this feature.

Best Regards!

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*

ASN45

LV1

2022-02-22 18:39:16

Posts: 4

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-02-22

Information

Helpful: 0

Replies: 2

EAP610 seems to be using only 802.11a instead of ax

EAP610 seems to be using only 802.11a instead of ax

Information

Voters 0

Tags