REMOTE ACCESS ER605

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

REMOTE ACCESS ER605

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
REMOTE ACCESS ER605
REMOTE ACCESS ER605
2022-03-04 07:33:55
Model: ER605 (TL-R605)  
Hardware Version: V1
Firmware Version: 1.1.1 Build 20210723 Rel.64608

Hi Support

 

Good day,

 

Current setup

Connection Type: PPPoE and internet connection is working fine

 

How to access TL-ER605 GUI (Web) via remote access from outside (Different location)?

 

 

Thank you

  0      
  0      
#1
Options
3 Reply
Re:REMOTE ACCESS ER605
2022-03-08 07:34:17

Dear @ken22 ,

 

ken22 wrote

Connection Type: PPPoE and internet connection is working fine

How to access TL-ER605 GUI (Web) via remote access from outside (Different location)?

 

You can set the Remote management on this router, please refer to this link:

How to configure remote management on SMB router?

 

Best Regards!

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options
Re:REMOTE ACCESS ER605
2022-04-04 09:33:40 - last edited 2022-04-04 09:34:03

 Hi !

My router Model: ER605 (TL-R605)  .

 

I'm also trying to perform remote management as written in the user manual, but it doesn't work for me either.

The router is on a local network and I cannot perform remote management from a computer connected to the WAN port directly.

 

Thank you!

  0  
  0  
#3
Options
Re:REMOTE ACCESS ER605
2022-04-04 11:31:53 - last edited 2022-04-04 11:35:00

  @EDS_me 

Are you getting a public IP address on your WAN on ER605? If you don't get public on WAN stats on ER605, you cannot use remote management like in the User Guide.

For your convenience, if you don't get a public IP when you check your WAN stats, please set your modem router to bridge mode. Do not use it in router mode. Double NAT will causes issue like this.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  1  
  1  
#4
Options