Configuring failover to backup WAN

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Configuring failover to backup WAN

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Configuring failover to backup WAN
Configuring failover to backup WAN
2022-03-06 13:29:58
Model: ER605 (TL-R605)  
Hardware Version: V1
Firmware Version: 1.2.0

I have a broadband connection on WAN and an LTE modem connected to my WAN/LAN1 port. I need to configure it to only use the WAN/LAN1 port when the WAN port fails, but that's not how it's working. With current configuration it's always appearing to use the WAN/LAN1 connection, my connection speed and my external IP address are that of the LTE ISP.

 

WAN settings:

 

Load balancing settings:

Link backup rule:

  0      
  0      
#1
Options
1 Reply
Re:Configuring failover to backup WAN
2022-03-06 13:37:17

Got it to work after reading other threads. Switched to Manual Mode for online detection for each port and turned Load Balancing back on.

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 217

Replies: 1