Block Incomming IP´s

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Block Incomming IP´s

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Block Incomming IP´s
Block Incomming IP´s
2022-03-07 12:26:08 - last edited 2023-03-06 14:26:07
Model: ER605 (TL-R605)  
Hardware Version: V1
Firmware Version: 1.1.1 Build 20210723 Rel.64608

Hi, 

 

I would like to know how to configure the equipment through Omada Controller so that certain IPs could not access the network. For example, how would I have to do so that the IPs in the range 78.128.113.1 to 78.128.113.255 cannot access from the WAN to the LAN.

 

I need to create several ACL´s to certain ranges of IPs but I can only block outgoing not incomming.

 

Thanks and regards.

  0      
  0      
#1
Options
1 Accepted Solution
Re:Block Incomming IP´s-Solution
2022-03-08 09:13:14 - last edited 2023-03-06 14:26:07

Dear @Groucho71 ,

 

Groucho71 wrote

I would like to know how to configure the equipment through Omada Controller so that certain IPs could not access the network. For example, how would I have to do so that the IPs in the range 78.128.113.1 to 78.128.113.255 cannot access from the WAN to the LAN.

I need to create several ACL´s to certain ranges of IPs but I can only block outgoing not incomming.

 

You can refer to this FAQ which is the similar situation:

How to limit specific IP to access to internal server by TP-LINK SMB router?

 

Please set the corresponding IP Group firstly, and set the first rule to allow this IP group to access devices in LAN.

And set the second rule to deny ip-group any access the devices in LAN.

 

Best Regards!

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Block Incomming IP´s-Solution
2022-03-08 09:13:14 - last edited 2023-03-06 14:26:07

Dear @Groucho71 ,

 

Groucho71 wrote

I would like to know how to configure the equipment through Omada Controller so that certain IPs could not access the network. For example, how would I have to do so that the IPs in the range 78.128.113.1 to 78.128.113.255 cannot access from the WAN to the LAN.

I need to create several ACL´s to certain ranges of IPs but I can only block outgoing not incomming.

 

You can refer to this FAQ which is the similar situation:

How to limit specific IP to access to internal server by TP-LINK SMB router?

 

Please set the corresponding IP Group firstly, and set the first rule to allow this IP group to access devices in LAN.

And set the second rule to deny ip-group any access the devices in LAN.

 

Best Regards!

Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 339

Replies: 1