Pre-recorded Time

Pre-recorded Time
Pre-recorded Time
2022-03-20 21:58:17
Hardware Version: V1
Firmware Version: NVR1016H(UN)_V1_210825

Hello folks, i have a trable with the Pre-recorded Time setting. By default, it is set to 5 seconds, but recording starts 1-2 seconds after the event occurred (motion detection). I tried changing the time to 1, 3, 10, 15, 20 and 30 seconds, but nothing changed. It looks like this setting doesn't work.

 

Model:

NVR1016H(UN)_V1

Firmware:

NVR1016H(UN)_V1_210825

 

Cameras:

4th tapo c310v1

0
0
#1
Options
2 Reply
Re:Pre-recorded Time
2022-03-21 05:59:18

Dear @Metalruler

 

Metalruler wrote

Hello folks, i have a trable with the Pre-recorded Time setting. By default, it is set to 5 seconds, but recording starts 1-2 seconds after the event occurred (motion detection). I tried changing the time to 1, 3, 10, 15, 20 and 30 seconds, but nothing changed. It looks like this setting doesn't work.

 

Could you please provide a screenshot to show your issue?

How did you confirm this function doesn't work?

 

Best Regards!

If this was helpful click the Triangles button below. If this solved your issue, please mark it "Recommended Solution" to help others.
0
0
#2
Options
Re:Pre-recorded Time
2022-03-21 13:18:30

  @Hank21 

Maybe I didn't describe the problem clearly. The Pre-recorded Time is needed to compensate for the motion detection delay. For any value of the parameter (1-30 sec), recording starts at the moment of motion detection. I came to this conclusion by watching the recorded videos.

Although, with a parameter value of 5 seconds, the recording should start 5 seconds earlier of the event detection.

 

Hope this clear.

Thanks

0
0
#3
Options