ER605 DMZ problem

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ER605 DMZ problem

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
ER605 DMZ problem
ER605 DMZ problem
2022-04-22 15:47:29
Model: ER605 (TL-R605)  
Hardware Version: V1
Firmware Version: 1.2.0

Hello !

 

I've got a problem with the DMZ. 

No matter what settings i make using DMZ or virtual servers, or whatever, i can't access my server from outside LAN.

I don't use a controller, it's only the router. The strange thing is this : i've setup noip in the settings (since i have ppope connection), but can't access it also. The IP update works, because in the control panel of the NOIP, i can see the IP change. Also, my ISP provides a noip service, and that one works only from inside the LAN.

 

The NOIP my ISP provides is curte(dot)home(dot)ro . If i acces it from LAN, it works as it should. From outside it doesn't.

The NOIP set in the ER605 settings doesn't work at all, not even from LAN.

  0      
  0      
#1
Options
2 Reply
Re:ER605 DMZ problem
2022-04-22 18:59:18

  @oxyg3n 

 

I don’t have a solution for you, but note that curte(dot)home(dot)ro resolves to a private address in the address range used by some ISPs internally (100.64.0.0–100.127.255.255). As such, it is not accessible from Internet.

 

https://en.wikipedia.org/wiki/Reserved_IP_addresses

https://en.wikipedia.org/wiki/Carrier-grade_NAT

 

Kris K
  0  
  0  
#2
Options
Re:ER605 DMZ problem
2022-04-22 19:13:55

  @KJK 

 

Apparently the dns did not have enough time to propagate. Now it works on that (dot)home. And it should have that ip range since that is the ip the ppope alocated.

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 1128

Replies: 2

Related Articles