VLAN on ETH2
Where do I find the VLAN setting for the ETH2 port?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
As far I know is not possible, is just like a bridge for mgmt or native vlan.
If you want to set the vlan for eth port you should have to use EAP235/615 wall plate.
Best Regards
- Copy Link
- Report Inappropriate Content
As far I know is not possible, is just like a bridge for mgmt or native vlan.
If you want to set the vlan for eth port you should have to use EAP235/615 wall plate.
Best Regards
- Copy Link
- Report Inappropriate Content
I posted the question on Amazon and I got this response:
"Yes this access point supports vlan. You configure it through the access point management interface or using tplink Omaha controller software. You will need a separate router/firewall to make the vlan work."
I set the vlan id to 1 on the management interface and it did not work. Devices connected to the ETH2 do not get an IP from the router.
Any idea what that setting is for?
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 718
Replies: 2
Voters 0
No one has voted for it yet.