Omada Controller Software - LAG / LACP - Add Switch Settings for port-channel load-balance

Omada Controller Software - LAG / LACP - Add Switch Settings for port-channel load-balance
Omada Controller Software - LAG / LACP - Add Switch Settings for port-channel load-balance
2022-06-23 14:12:15
Model: OC200
Hardware Version: V1
Firmware Version: 1.15.2 Build 20220323 Rel.60717

Greetings.

 

The Omada controller software has general LAG configuration but it lacks a way to set the port-channel load-balance algorithm of the LAG.

 

When the switches are in standalone mode this parameter is available in their web GUI:

 

Jetstream Switch User Guide

 

(section 3.2.3, page 126)

 

as well as their CLI:

 

Jetstream Switch CLI Reference Guide

 

(chapter 13.2, page 104)

 

However when they are under the control of the Omada software they cannot be managed via their web GUI nor their CLI and this parameter does not appear in the Omada GUI so there doesn't appear to be a way to set/change it.

 

Could this setting be surfaced in the Omada Controller Software GUI?

 

Additionally, there are two other LACP commands available in standalone mode that aren't in the Omada GUI - system-priority and port-priority, it would be nice if these could be surfaced in the Omada GUI as well.

 

Thanks!

7
7
#1
Options
2 Reply
Re:Omada Controller Software - LAG / LACP - Add Switch Settings for port-channel load-balance
2022-06-24 06:42:27

 Hi @user223344 

 

This has been forwarded to the developer team for further evaluation.

With more voice, the feature might have more chance to be supported earlier. Cheers!

If this was helpful click the Triangles button below. If this solved your issue, please mark it "Recommended Solution" to help others.
0
0
#2
Options
Re:Omada Controller Software - LAG / LACP - Add Switch Settings for port-channel load-balance
2022-07-02 05:29:44

  @Hank21 

 

+1 for this request, would also like to see this in Omada, thanks.

0
0
#3
Options