Requests & Suggestions
2
VotesWelcome to the Feature Request Board for TP-Link products! This "Requests & Suggestions" (Link) board is to serve as a suggestion box where you can propose ideas for improving TP-Link Business product
By
Fae
Fae8195Views
2
VotesDescription / Current Behavior: Currently, the Omada Controller displays raw IP addresses in many sections of the interface without resolving them to the actual device names. This requires users to co
GUI
220Views
1
Votesit would be great if TP-Link could maintain comprehensive list of hardware that support a given feature. for instance TP-Link Documentation have steps to enable Adpative optimisation. however the docu
By
ivansikorsky
· Latest post Yesterday
by ivansikorsky
306Views
0
VotesDear TP-Link Support, I would like to request the restoration of the per‑AP WiFi scheduling feature in Omada. This functionality existed in earlier versions and allowed individual access points to fol
By
vspredator
27Views
23
VotesEAP773 currently broadcasts a "TP_TX_VAP" SSID when the 6ghz band is active, which is enabled for certain devices with early implementations of WiFi 6E/7. Broadcasting the SSID was employed by several
9251Views
0
VotesHello, I'd like to propose the following UI change. In a situation where you have at least a second WAN, and you enable Link Backup, the status of the backup WAN will be shown as "Offline", and you'll
By
DaanWasTaken
· Latest post Friday
by Silly_Goose
104Views
0
VotesHi all, I'm just got into troubles.... While investigating an network issue, i've decided to shut down temprarily the WireGuard site-2-site VPN, unfortunately I did it on the wrong (remote) site and n
83Views
0
VotesHello, I'd like to put my suggestion forward about the possibility of restricting a certain number of IP addresses to be distributed by the DHCP without the need to produce a randomised fake MAC addre
DHCP
96Views
1
Voteshi, in reference to my post, I would like to sugest adding WireGuard (and/or other VPN) controls to the Gateway CLI, which would be very helpful
CLI
By
ZoloNN
60Views
56
VotesHi, I would like to request the addition of IPv6 support for WireGuard. IPv6 adoption has increased significantly, doubling from 2020 to 2024, and now reaches approximately 75% in countries like Germa
IPv6
6921Views
24
VotesCurrently, the omada controller offers the option to set the WiFi security mode to "WPA2/WPA3". However, there isn't an option to exclusively use WPA3 security protocol. Adding a "WPA3 Only" option wo
By
reynhartono
· Latest post Wednesday
by kheinerimm1206
10919Views
0
Votes43Views