Can't disable interface eg. WAN/LAN3 with omada controler on ER605
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Trying to disable interface for LAN (DEFAULT) network on ER605 witch omada software controller 5.3.1.
Getting "The interface of Default LAN cannot be modified.".
So - how to protect router ports same way as switch ports can be disabled (eg. TL-SG2008P) ?
yes and no, you can not disable any ports on the router when using Omada SDN controller, you can also not change on deafult LAN, you must do so the router must run in stand alone mode. I have blinded these ports with a blind lid without a key so that no one connects anything by mistake, :-)
I use this, this is chep
yes and no, you can not disable any ports on the router when using Omada SDN controller, you can also not change on deafult LAN, you must do so the router must run in stand alone mode. I have blinded these ports with a blind lid without a key so that no one connects anything by mistake, :-)
I use this, this is chep