ER605 WAN Load Balancing and Down detection (on bad connection)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ER605 WAN Load Balancing and Down detection (on bad connection)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
ER605 WAN Load Balancing and Down detection (on bad connection)
ER605 WAN Load Balancing and Down detection (on bad connection)
2022-09-14 17:22:05
Model: ER605 (TL-R605)  
Hardware Version: V2
Firmware Version: 2.0.1

Hi,

 

I'm dependant on using WAN Load Balancing to improve the Internet Bandwidth for Multiple Users/Applications.
On WAN1 i do have a VDSL line conncted (Provider Modem/Router, NAT active)
ON WAN2 i'm using a LTE Router (Provider Modem/Router, NAT active)

Now on bad weather conditions the LTE Router get's high latency (2000ms) and low bandwidth (100kbit/s and less)


Has anyone figured a way out to stop the WAN Load Balancing from routing the traffic to the interface when it has issues (latency, bandwidth)
Because the "Gateway" of the WAN's will still be reachable as it's the corrosponding provider routers NAT-Gateway.

 

Thanks

  1      
  1      
#1
Options
1 Reply
Re:ER605 WAN Load Balancing and Down detection (on bad connection)
2022-09-15 08:25:53

  @TopicsLP 

 

This gateway is probably not so smart, you can set a smaller percentage for WANs with latency, go to Network --- WAN, this interface allows you to set Upstream bandwidth and downstream bandwidth, set a smaller percentage for WANs with problems.

Just striving to develop myself while helping others.
  0  
  0  
#2
Options