WLAN with "Guest network" enabled - and access to the whole LAN

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

WLAN with "Guest network" enabled - and access to the whole LAN

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
WLAN with "Guest network" enabled - and access to the whole LAN
WLAN with "Guest network" enabled - and access to the whole LAN
2022-09-20 20:40:34

As in the title, I have two EAP320 with an controller running. Defined a wlan with "guest network" enabled, but can reach and scan the whole network.

What have I done wrong?

After some research : I have read, that this is because of IPv6, only IPv4 will be blocked. How can I disable IPv6 traffic? At the moment, this feature is useless.

  0      
  0      
#1
Options
3 Reply
Re:WLAN with "Guest network" enabled - and access to the whole LAN
2022-09-21 00:14:09
Www.MdAklas796
skaklas796@gmail.com
  0  
  0  
#2
Options
Re:WLAN with "Guest network" enabled - and access to the whole LAN
2022-09-21 05:28:01

  @Andreas_Koelner 

 

Try to configure the Access Control manually. EAP320 is an old version AP and it may not support Guest Network(although on controller you have this option it may not work for EAP320)

I have EAP120 old version and it does not support Guest Network, but under my test if I set up Access Control, it works the same as "guest network".

 

See the instruction Method 2

  0  
  0  
#3
Options
Re:WLAN with "Guest network" enabled - and access to the whole LAN
2022-09-21 06:03:55
I have both. Once I have the "guest network" feature on at the WLAN in the controller, but also a access control list active for this WLAN: Rule Name: WLAN frei Rule Mode: Block Rule Members: Subnets: 192.168.250.0/24 Add New Exclude Subnets: 192.168.250.254/32 <-- my router Add New Apply But I can access all devices, with IP4 also.
  0  
  0  
#4
Options