CLI not working as expected

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

CLI not working as expected

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CLI not working as expected
CLI not working as expected
2022-09-23 21:05:01
Tags: #CLI
Model: SG2210MP  
Hardware Version: V1
Firmware Version: 1.0.5 Build 20220909 Rel.75392

I am trying to access my TL-SG2210MP V1 switch using the CLI. I've found the documentation (https://static.tp-link.com/2020/202011/20201103/1910012904_T16_T26_CLI.pdf) at the dutch support page: https://www.tp-link.com/nl-be/support/download/tl-sg2210mp/v1/.

 


I can enter 'Privileged EXEC Mode' but I am unable to get into 'Global Configuration Mode', I am getting a bad command error. I also find the amount of possible commands limited:

 

 

NOTE:

 

  • switch firmware = 1.0.5 Build 20220909 Rel.75392
  • I am using the device account specified in the controller (using the UI)

 

 

Can someone help me? All help is appreciated!

 

  0      
  0      
#1
Options
1 Reply
Re:CLI not working as expected
2022-09-26 04:44:16

Jdruwe wrote


I can enter 'Privileged EXEC Mode' but I am unable to get into 'Global Configuration Mode', I am getting a bad command error. I also find the amount of possible commands limited:

Can someone help me? All help is appreciated!

 

Dear  @Jdruwe 

 

May I know how you managed this TL-SG2210MP V1 switch before?

 

If the switch has been managed by an Omada Controller before, then the CLI command will not take effect. 

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options