Load Balancing with Link Backup Mode not working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

2022-11-09 00:18:28

Posts: 7

Helpful: 1

Solutions: 0

Stories: 0

Registered: 2022-05-30

Load Balancing with Link Backup Mode not working

2022-11-09 00:18:28

Model: OC200

Hardware Version: V2

Firmware Version: 2.6.1

Hi, I recently updated my OC200 to the latest version.

I have two ISPs, WAN is 100mbps and WAN/LAN1 is 150mbps, before the update my load balancing and backup setup are as follows:

After the update, load balancing is not working as it used to be anymore, at speedtest it does not "combine" the speed of two WANs.

Before speedtest show 250mbps, now I can only get 100mbps from WAN and nothing from WAN/LAN1 as if it is only there for backup.

Also, I can confirm this with the ISP Load widget, before both WAN and WAN/LAN1 has values in it.

But after the update, WAN/LAN1 is not being used anymore.

1 Reply

LV5

2022-11-09 13:06:45

Posts: 2588

Helpful: 349

Solutions: 191

Stories: 0

Registered: 2021-05-10

Re:Load Balancing with Link Backup Mode not working

2022-11-09 13:06:45

I have also upgraded the controller to 5.6.4 and have not encountered this problem.

Have you tried reconfiguring it and testing again?

Just striving to develop myself while helping others.