EAP225 low connectivity in mesh

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP225 low connectivity in mesh

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP225 low connectivity in mesh
EAP225 low connectivity in mesh
2022-11-18 20:20:40 - last edited 2022-11-19 09:51:01
Model: EAP225-Outdoor  
Hardware Version: V3
Firmware Version: 5.0.8

Below is the layout of our RV Parks Mesh Network. Note the EAP in the center is the wired EAP610 Outdoor.  The rest are EAP225 Outdoor in Mesh.  The Entrance EAP is direct to the EAP610.  The Fence EAP hops through Entrance EAP.  My issue is that clients that are to the left and above Entrance EAP have slowly dropped and migrated to the Fence EAP.  The Entrance EAP has a stronger connection to the centrally located EAP610 and a week ago had 10 clients, but now it is down to one. Any ideas on what is happening? 

055611d471e0448491ce62808dd57b9a

 

  0      
  0      
#1
Options
1 Reply
Re:EAP225 low connectivity in mesh
2022-11-21 12:55:06

  @RickJamesBish 

 

You can try changing the Tx Power. If you turn it up, the EAP threshold for client connections will be larger, if you turn it down, it will be smaller.

This way you can adjust the Tx Power of the EAP at the entrance to be larger and the one further away to be smaller.

Just striving to develop myself while helping others.
  1  
  1  
#2
Options