Second ER7206 needed in network

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Second ER7206 needed in network

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Second ER7206 needed in network
Second ER7206 needed in network
2022-12-12 17:28:27 - last edited 2024-06-10 03:06:23
Hardware Version:
Firmware Version: 5.7.4

A configuration I have used at a number of locations is to have a router on one ISP with my inside default gateway address and at another part of the campus a router connected to a second ISP with a unique inside address.  The secondary is used for testing and in case of failure of the primary ISP or issues at that location we can change the IP on the secondary unit and continue to function.

I tried to set this up in OMADA and it will not allow me to connect the second ER7206.  Am I doing something wrong or is this by design?  This is a very useful feature for the redundancy and also in a multibuilding campus if you have a failure of the link between building then both can have some level of connectivity.

Any ideas would be appreciated.

  0      
  0      
#1
Options
1 Accepted Solution
Re:Second ER7206 needed in network-Solution
2022-12-13 05:04:56 - last edited 2024-06-10 03:06:23

  @MikeW1 

I'm not familiar with your network design, but one thing I know i that on Omada Controller, one site can only adopt one ER7206 gateway.

 

If you want to adopt 2nd ER7206, you have to create a new Site on the controller.

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Second ER7206 needed in network-Solution
2022-12-13 05:04:56 - last edited 2024-06-10 03:06:23

  @MikeW1 

I'm not familiar with your network design, but one thing I know i that on Omada Controller, one site can only adopt one ER7206 gateway.

 

If you want to adopt 2nd ER7206, you have to create a new Site on the controller.

Recommended Solution
  0  
  0  
#2
Options