trouble resetting er605

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

trouble resetting er605

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
trouble resetting er605
trouble resetting er605
2023-02-05 19:32:03
Model: ER605 (TL-R605)  
Hardware Version: V2
Firmware Version:

Hi,
Does anyone know of an exact procedure to resetting an er605? I have 2 on my desk that are just not allowing me to. As in they are no longer accessible and the reset button thus far does not seem to be working. I have tried holding it while powering up. Holding it while on. I have even taped a screw in to the reset button and left it. THis is happening on both. They are new and i assume it was something  did with the adoption part as they were routing prior to that.
any ideas?

  0      
  0      
#1
Options
1 Reply
Re:trouble resetting er605
2023-02-07 07:09:42 - last edited 2023-02-07 07:10:31

krede wrote

Hi,
Does anyone know of an exact procedure to resetting an er605? I have 2 on my desk that are just not allowing me to. As in they are no longer accessible and the reset button thus far does not seem to be working. I have tried holding it while powering up. Holding it while on. I have even taped a screw in to the reset button and left it. THis is happening on both. They are new and i assume it was something  did with the adoption part as they were routing prior to that.
any ideas?

Dear  @krede 

 

Have you tried to keep the router power on for 10 minutes then push the RESET hole again for 10 seconds?

 

Sometimes the ER605 v2 requires 10-15min to reboot(if it lost power when configuring by the controller). Reset may not take effect before it booting up. 

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options