Business Community > Controllers > Time Range for IP, IP Group, MAC address or LAN port
< Controllers

Time Range for IP, IP Group, MAC address or LAN port

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Time Range for IP, IP Group, MAC address or LAN port

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Time Range for IP, IP Group, MAC address or LAN port
Time Range for IP, IP Group, MAC address or LAN port
2023-03-21 13:53:22 - last edited 2023-03-21 14:06:14
Model: OC200   ER605 (TL-R605)   SG2008P  
Hardware Version: V1
Firmware Version: 1.21.7 Build 20221206 Rel.58608

Hello,

is there already any option to set the time range when the client can access the internet? Client is connected to the TL-SG2008P on the LAN port.

Thank you

HW Controller: OC220 1.0 Gateway: ER707-M2 v1.20 Switch: SG2210XMP-M2 v1.0 AP: EAP773(EU) v1.0
  0      
 
  0      
 
#1
Options
4 Reply
Re:Time Range for IP, IP Group, MAC address or LAN port
2023-03-22 06:22:37

  @PavelV 

 

Hi, if you are using OC200 5.7.6, you can set the switch ACL with the Time range.

 

Just striving to develop myself while helping others.
  0  
  0  
#2
Options
Re:Time Range for IP, IP Group, MAC address or LAN port
2023-03-23 10:48:15

  @Virgo Hello, thank you,

I've tried everything possible, the ACL rule doesn't work for me, even if it's not limited by time. Where am I wrong? I need to block one switch port at a specified time.

Pavel

 

 

HW Controller: OC220 1.0 Gateway: ER707-M2 v1.20 Switch: SG2210XMP-M2 v1.0 AP: EAP773(EU) v1.0
  0  
  0  
#3
Options
Re:Time Range for IP, IP Group, MAC address or LAN port
2023-03-24 01:49:48

  @PavelV 

 

Does your switch TL-SG2008P firmware version latest one?

The latest firmware of V1, V2, and V3 all support time-based ACL.

Just striving to develop myself while helping others.
  0  
  0  
#4
Options
Re:Time Range for IP, IP Group, MAC address or LAN port
2023-03-24 09:05:12

  @Virgo 

Hello,

I have an up-to-date fw switch. There is no problem in setting the times. I tested on a different port with a TV connected and Netflix on. When I set the block time, Netflix continues to work normally, but if I change the movie or rewind it, the connection drops. After the blocking time expires, Netflix will load again. Another port where the computer is connected was downloading a large amount of data. However, when the blocking time was active, the download continued and even turning the ACL on and off did not help, I also set other ACL without a time limit. The PC was still downloading data without limitation.

Pavel

HW Controller: OC220 1.0 Gateway: ER707-M2 v1.20 Switch: SG2210XMP-M2 v1.0 AP: EAP773(EU) v1.0
  0  
  0  
#5
Options

Information

Helpful: 0

Views: 1511

Replies: 4

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.