Switchport Configuration EAP225

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Switchport Configuration EAP225

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Switchport Configuration EAP225
Switchport Configuration EAP225
2023-06-26 16:55:29
Model: EAP225  
Hardware Version: V3
Firmware Version: 5.05

Hello Everyone! This is the first time that I wrote in this community so be gentle please.  I'm having troubles with my EAP225. I connect the EAP225 to a cisco 4507 GE port configured first on access vlan 53 (53 mgmt vlan) and I adopt it normally but I really need to pass 2 vlans (44, mgmt: 53) and when I configured the port in trunk mode passing both vlans the Omada OC200 shows it DISCONNECTED. Can somebody help me with this issue?

 

PS: The omada OC200 is connected to a port in access vlan 53

  0      
  0      
#1
Options
2 Reply
Re:Switchport Configuration EAP225
2023-06-27 03:12:57

  @amarcano 

 

If it worked when the AP was connected to an access port in VLAN53, it should also work with a trunk port where the native VLAN is 53. Alternatively, you may like to use the General port mode instead of the Trunk mode and make the port UNTAGGED in VLAN53 with the PVID set to 53. This is actually the method I use.

Kris K
  0  
  0  
#2
Options
Re:Switchport Configuration EAP225
2023-06-27 15:48:32

  @KJK Thanks very much for your help. I configured the trunk port with with native vlan 53. Now I want pass dhcp traffic(on vlan 44) through the EAP225. My DHCP server is running on a VM and I need to do some tests. Thank again

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 331

Replies: 2

Related Articles