Configuring older access point
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi
I have a EAP120. It does not come up in the search. I'm trying to configure it to extend my existing wifi signal to the "dead" areas in my house. I realise it is an older model but I am assured it should do the job. I'm not too tech savvy so would prefer easy to understand instructions
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Reset the AP to its factory defaults and use method 1 from this video tutorial for configuring the AP. Use method 2 from the tutorial if you still can't see the AP's SSID.
"RESET: With the device powered on, press and hold the RESET button for about 8 seconds until the LED flashes red, then release the button. The device will restore to factory default settings."
- Copy Link
- Report Inappropriate Content
Do I set the SSID to my existing SSID from my router?
Should my devices automaticaly switch between them?
Thanks
- Copy Link
- Report Inappropriate Content
You can set APs SSID either the same or different from your router's SSID - it's your choice.
Roaming smoothness between them will depend on the devices you use in your network.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 576
Replies: 3
Voters 0
No one has voted for it yet.