5.13.9, ER7602 SPF WAN port...

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

5.13.9, ER7602 SPF WAN port...

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
5.13.9, ER7602 SPF WAN port...
5.13.9, ER7602 SPF WAN port...
2023-10-27 18:23:03 - last edited 2023-10-28 18:25:59

With the previous controller... I have the SPF WAN port disabled as a WAN port.  

 

With 5.13.9, it forces you to enable it... then it forces you to adjust the load balancing for 3 ports (I have 2 active WANs).

 

The fail-over section DOES the SFP port.  

 

It also shows that it's "enabled" with a green light.

 

I can not teach anyone anything - I can only make them think - Socrates
  0      
  0      
#1
Options
2 Reply
Re:5.13.9, ER7602 SPF WAN port...
2023-10-28 18:23:40

It would be nice to go back and disable the WAN ports that you want, not forcibly have them enabled.  

 

It throws off all the other dashboard entries that I look at... 

 

I legit have nothing plugged into this port, it shows enabled in the WAN settings page.  

 

I can not teach anyone anything - I can only make them think - Socrates
  0  
  0  
#2
Options
Re:5.13.9, ER7602 SPF WAN port...
2023-10-30 06:32:53

Hello @KimcheeGUN

 

Thank you for your valuable feedback.

I've recorded this request and will report it to the developer team for evaluation.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  1  
  1  
#3
Options