VIGI NVR1008H - No video and deeping
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
When installing the VIGI NVR 1008H there was no video out ( HDMI / VGA ). During the start up process there were 3 beeps. After installing the hard drive and reboot the beeps continues and does not stop.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @cctvnoob
Thanks for posting in our business forum.
It beeps when it starts up. But after that, it should stabilize and work as expected.
So what you said now is a typical issue where the hard drive is either not installed properly or it is not formatted on the NVR.
- Copy Link
- Report Inappropriate Content
Hi @cctvnoob
Thanks for posting in our business forum.
It beeps when it starts up. But after that, it should stabilize and work as expected.
So what you said now is a typical issue where the hard drive is either not installed properly or it is not formatted on the NVR.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 924
Replies: 1
Voters 0
No one has voted for it yet.