Home

Forums

Stories

Knowledge Base

Business Community > Switches > system time problem 2006-01-01 08:00 for T2600G-28TS

< Switches

system time problem 2006-01-01 08:00 for T2600G-28TS

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

system time problem 2006-01-01 08:00 for T2600G-28TS

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

comp-eng-louis

2024-01-25 03:00:08 - last edited 2024-01-26 01:41:33

Posts: 6

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-01-23

system time problem 2006-01-01 08:00 for T2600G-28TS

2024-01-25 03:00:08 - last edited 2024-01-26 01:41:33

Model: T2600G-28TS(TL-SG3424)

Hardware Version: V3

Firmware Version: 3.0.3

System time problem for T2600G-28TS

After manual set the system time to current time, e.g. 2024-01-25 10:45

save config

reboot switch

the switch system time went back to 2006-01-01 08:00

Simple:

For each reboot, or (shutdown & power on), then system time will go back to 2006-01-01 08:00

save config

reboot

Time go back to 2006-01-01

1 Accepted Solution

Clive_A

2024-01-25 05:48:56 - last edited 2024-01-26 01:41:33

Posts: 8362

Helpful: 4338

Solutions: 2191

Stories: 0

Registered: 2023-06-09

Re:system time problem 2006-01-01 08:00 for T2600G-28TS-Solution

2024-01-25 05:48:56 - last edited 2024-01-26 01:41:33

Hi @comp-eng-louis

Thanks for posting in our business forum.

This is expected to be normal. The flash does not save time but requires you to sync manually.

Or if your model supports the Omada controller, you can use the controller to proactively sync the time to the switch.

Recommended Solution

2 Reply

Clive_A

2024-01-25 05:48:56 - last edited 2024-01-26 01:41:33

Posts: 8362

Helpful: 4338

Solutions: 2191

Stories: 0

Registered: 2023-06-09

Re:system time problem 2006-01-01 08:00 for T2600G-28TS-Solution

2024-01-25 05:48:56 - last edited 2024-01-26 01:41:33

Hi @comp-eng-louis

Thanks for posting in our business forum.

This is expected to be normal. The flash does not save time but requires you to sync manually.

Or if your model supports the Omada controller, you can use the controller to proactively sync the time to the switch.

system time problem 2006-01-01 08:00 for T2600G-28TS

system time problem 2006-01-01 08:00 for T2600G-28TS

Information

Voters 0

Tags