Switching from GW VLAN to L3 Switch VLAN -> High retry rate in Mesh network

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Switching from GW VLAN to L3 Switch VLAN -> High retry rate in Mesh network

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Switching from GW VLAN to L3 Switch VLAN -> High retry rate in Mesh network
Switching from GW VLAN to L3 Switch VLAN -> High retry rate in Mesh network
2024-02-14 01:21:26

Discovered possibly some bug

 

Created VLAN89 in VLAN mode in Omada Controller OC200, switches only

 

 

Set the static IP in the switch, for l3 routing

 

 

Set this new VLAN89 as default untagged VLAN for all APs profile, all APs use mgmt VLAN1 which is tagged ofc.

 

Then set clients connected to mesh AP, IP 10.10.89.xx/Netmask 255.255.255.0/GW10.10.89.250 Manually..

 

Since then, AP in mesh shows high retry rate, although all clients in this particular VLAN are connected without any problems and accessible (from NVR which has set static route 10.10.89.0 , 255.255.255.0, gw in nvr vlan (switch IP in particular VLAN interface so all routing between NVR vlan and CAM vlan is done on switch directly)..

 

  0      
  0      
#1
Options