Hi All 

have been using Cisco switches with a single AP on a lot of our business networks so never needed the Mesh feature or controller. However in my home network I built it using the controller and has the following 

By home hub

oc200 

3 x EAP225

2 x EAP235 wall mount

1 x EAP225 outdoor

1 x Cisco switch single vlan 

however now looking to expand and configure my network with multiple vlans due to network devices being added for automation cctv distribution 

Thinking of the following devices

primary Cisco switch 10port (switch under stairs with fibre link and by hub)

28port in the office 

10port in loft 1

10port in loft 2 

10port in cabin fed from mesh eap 

vlans

vlan10 ip range 192.168.1.1-254 

vlan11 ip range 192.168.10.1-254 CCTV / ACCESS

vlan12 ip range 192.168.11.1-254 DANTE

vlan13 ip range 192.168.12.1-254 AVOIP

vlan14 ip range 192.168.13.1-254 home automation

all devices will be either static configured or Static assigned via MAC address either on the switch or via controller "controller preferably" With DHCP from oc200  on vlan 10 nothing else 

internet routing on vlan 10,11,14

looking for a bit of advice on how to build my home network to utilise the Omada controller and mesh features rather than starting again I'm happy to wipe all settings and start with a clean slate 

also not against swapping the BT home hub and the fibre interface to something tplink if it's going to make progressing simpler than retaining