RAHNetworks wrote

I have configured the two CPE710s as AP-Client and they are communicating properly on my default lan.

 

Problem is I am not able to pass the tagged networks to the switch on the client side of the connection.

 

Router - Switch (A) - CPE710 (AP)  ---  CPE710 (Client) - Switch (D)

 

Switch (A)  has port 24 is set to All and has trunk traffic.  Port 18 is set to All and is connected to the CPE710 (AP).

 

Switch (D) has port 1 set to All and is connected to the CPE710 (Client).  Connected my laptop to port 2 which is set to All and I can launch Omada Controller and get to the internet.  

 

Set port 10 on Switch (D) to Business network and the connected computer cannot get IP address and therefore has no network or internet access

 

What am I possibly missing in my configuration of the switches and the CPE710s?

 

Thanks

Hi @RAHNetworks 

Have you configured any advanced settings on CPE710? Generally the CPE wireless bridge can be treated as an Ethernet cable. You can try to upgrade the CPE to latest firmware and try again.

You may refer to the previous thread which has similar scenario.