No Admin Key (LACP) in Omada controlled switches

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

No Admin Key (LACP) in Omada controlled switches

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

mbze430

2024-05-29 02:56:50 - last edited 2024-06-19 08:37:19

Posts: 51

Helpful: 8

Solutions: 2

Stories: 0

Registered: 2019-04-20

No Admin Key (LACP) in Omada controlled switches

2024-05-29 02:56:50 - last edited 2024-06-19 08:37:19

Tags: #LAG

Model: TL-SX3206HPP

Hardware Version: V1

Firmware Version: 1.20

It doesn't appear that when a switch is under the Omada controller control there isn't a way to specific the 'admin key'. I assume it takes the LAG ID as the admin key? it would be really great if there was an option to allow the user to add it. I mean in standalone mode it let you do it. Why not in the controller mode?

1 Accepted Solution

Hank21

2024-06-19 08:36:24 - last edited 2024-06-19 08:37:19

Posts: 3673

Helpful: 719

Solutions: 497

Stories: 8

Registered: 2021-12-13

Re:No Admin Key (LACP) in Omada controlled switches-Solution

2024-06-19 08:36:24 - last edited 2024-06-19 08:37:19

@mbze430

Controller mode configuration differs from standalone configuration. The Admin Key in standalone mode refers to LAG ID in controller mode. Older switches utilize an admin key to group certain ports, while newer switches use group IDs instead.

You can compare these two articles.

How to configure LACP on our Smart/ Managed Switch

How to Configure LAG/LACP on TP-Link Omada switches in Controller Mode

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*

Recommended Solution