Slow Mesh speeds from EAP610-Outdoor to EAP610-Outdoor
I've created a mesh between a wired EAP610-Outdoor, and a remote EAP610-Outdoor. Signal strength is ~62dbi, Tx Rate: 432Mbps+, Rx Rate: 288Mbps+. When I do a speedtest to a local OpenSpeedtest server (on the same wired segment as the primary EAP610), I'm only seeing throughput from a wired client on the remote EAP610 of 70-80 mbps up and down, even though the link speed is 4-6x this. On the remote EAP610 there are no other 5ghz clients, and only a handful of 2.4Ghz clients, and their traffic according to Omada is only 50-10kbps when idle. I have manually set the 5Ghz channels across my AP's to make sure they are far apart and not causing interferance. There are no other AP's anywhere within a half mile of the property, so it's not interferance from other people's gear.
Any reason I shouldn't be reaching closer (80%ish) to the TX/RX rates?