OC200 1.0 Firmware 5.7.6 need to delete device connected

OC200 1.0 Firmware 5.7.6 need to delete device connected

OC200 1.0 Firmware 5.7.6 need to delete device connected
OC200 1.0 Firmware 5.7.6 need to delete device connected
2024-07-25 14:22:40 - last edited 2024-07-26 08:33:54
Model: OC200  
Hardware Version: V2
Firmware Version: 5.7.6

I need to delete the Router below it and restore the router LAN access with user name and password. Now I cannot as is managed by Omada Controller...Need help please.

  0      
  0      
#1
Options
1 Accepted Solution
Re:OC200 1.0 Firmware 5.7.6 need to delete device connected-Solution
2024-07-26 08:33:37 - last edited 2024-07-26 08:33:54

  @CCDan 

Can you still access the OC200? There is a forget option when you click on the device. Alternatively, you can reset the device by holding down the reset button.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
3 Reply
Re:OC200 1.0 Firmware 5.7.6 need to delete device connected-Solution
2024-07-26 08:33:37 - last edited 2024-07-26 08:33:54

  @CCDan 

Can you still access the OC200? There is a forget option when you click on the device. Alternatively, you can reset the device by holding down the reset button.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
Re:OC200 1.0 Firmware 5.7.6 need to delete device connected
2024-07-26 08:52:16 - last edited 2024-07-26 08:52:53

  @Hank21 Thanks. In between I've reset both OC200 and ER7206 and regained control over ER7206.

I didn't know that OC200 software is so complicated and gain access in full of router and is no  longer allowing to control it locally. This I personally consider a problem as sometimes is needed to get accessto the local router OR import in full in OC200 software the configuration of router as is and not needding to do it again manually each IP binding and DHCP reservation and so on...

I need to study more before adding the router under OC200 for good.

PS is not possible to forget it anymore but on;ly by factory reset...

  0  
  0  
#3
Options
Re:OC200 1.0 Firmware 5.7.6 need to delete device connected
2024-07-29 01:45:50

  @CCDan 

This is the current design. I will provide feedback to our related department regarding your suggestion. Thank you for providing feedback.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#4
Options