opnsense freeradius omada controller

opnsense freeradius omada controller

opnsense freeradius omada controller
opnsense freeradius omada controller
2024-08-13 22:30:41 - last edited 2024-08-14 01:17:36
Hi, I'm configuring the radius (freeradius on opnsense), I set the radius profile on the omada oc200 controller with ip 10.0.0.254 port 1812 and 1813 for accounting, I activated authentication with the created profile, but if I put a PC it asks me user and password, however the APs (I entered the IPs among the radius clients) do not authenticate and go offline on the port where the radius is active, I also tried MAC authentication but from the radius logs I do not receive any authentication requests from that ap.
  0      
  0      
#1
Options
5 Reply
Re:opnsense freeradius omada controller
2024-08-14 06:54:54

Hi  @manustar 

 

You may refer to this troubleshooting guide:

Troubleshooting for RADIUS Authentication Failure

  0  
  0  
#2
Options
Re:opnsense freeradius omada controller
2024-08-14 11:36:23

  hi @Vincent-TP 

 

the problem is not the authentication itself, but on freeradius I really don't see the request coming when an eap610 ap is connected to the port, but if I connect a PC to the same port (same configuration), I see the request on freeradius and by entering the credentials works

  0  
  0  
#3
Options
Re:opnsense freeradius omada controller
2024-08-15 09:33:37

Hi  @manustar 

 

Has the EAP's MAC address been added to the RADIUS server?

 

 

  0  
  0  
#4
Options
Re:opnsense freeradius omada controller
2024-08-29 14:55:10
yes, add the mac on user. the mac in usename and password, but not recive any request for authentication from ap
  0  
  0  
#5
Options
Re:opnsense freeradius omada controller
2024-09-11 16:21:20

  @manustar 

this the config authentication. on radius profile i insert the ip and port of the radius server. the port 3 allow all vlan

  0  
  0  
#6
Options