Omada Controller

Omada Controller

Omada Controller
Omada Controller
2024-09-04 03:46:46 - last edited 2024-09-05 02:37:24

hi. i've been trying to sort this out but not sure what is happening

i wanted to know which port from the switch the ap is connected so checked the topology.

i can confirm that both the ap is running through wired. mesh is disabled. 

but if u see below, the family area doesnt show which port it is connected to but instead showing it goes through dining area? and it doesnt show which port it is connected to the switch.

 

could anyone tell me what i'm doing wrong.

please and thank you

 

  0      
  0      
#1
Options
1 Accepted Solution
Re:Omada Controller-Solution
2024-09-04 08:40:06 - last edited 2024-09-05 02:37:24

  @ImranRn 

Have you turned on LLDP? If not, kindly try turning it on. Besides, you can try to reboot the network to check if that would help.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
2 Reply
Re:Omada Controller-Solution
2024-09-04 08:40:06 - last edited 2024-09-05 02:37:24

  @ImranRn 

Have you turned on LLDP? If not, kindly try turning it on. Besides, you can try to reboot the network to check if that would help.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
Re:Omada Controller
2024-09-04 12:05:07

  @Hank21 and just like that it works. just enable lldp. 

 

thank you so much!

  0  
  0  
#3
Options